เครื่องเตรียมชิ้นงานสำหรับเครื่องทดสอบแรงดึงแรงกด
Pneumatic Punching Machine Model ITK-A016
ตัวแบ่งส่วนข้อมูลนิวเมติกนี้ส่วนใหญ่จะใช้สําหรับชิ้นทดสอบมาตรฐานยาง
ควรใช้ร่วมกับแม่พิมพ์ตัดมาตรฐานเพื่อเชื่อมต่อแหล่งอากาศที่สูงกว่า 4KG
การผ่าตัด
1. วางตัวแบ่งส่วนข้อมูลบนระนาบปรับหมุดทั้งสี่ให้เรียบและใส่กาวตัด
2. ปรับสวิตช์วาล์วของเครื่องแยกน้ํามันและน้ําด้านหลังและปรับบารอมิเตอร์ให้มีอย่างน้อย 4KG
3. ใส่กาว PU ลงบนฟิล์มใส่กาวตัดบนฟิล์มใส่แม่พิมพ์ตัดบนฟิล์มจากนั้นกดสวิตช์ปุ่มสีแดงด้วยมือทั้งสองข้างพร้อมกัน (เพื่อความปลอดภัยต้องกดมือทั้งสองข้างพร้อมกัน)กดแผ่นดันลงไปที่แม่พิมพ์ตัด พักสักครู่ ปล่อยให้ยางตัดออกจนสุด แล้วปล่อย นําตัวอย่างออก
4. ปิดแหล่งอากาศหลังจากใช้งานหมด

Overview:
This pneumatic slicer is mainly used for rubber standard test pieces. It should be combined with standard cutting die to connect air source above 4KG.
Machine specifications:
1.Load: 1000KG.
2.The pressure plate diameter: Ф120 mm
3.Bottom plate: 230X250mm.
4.Effective height: 100mm.
5.Machine size: 280X330X430mm.
6.Machine weight: about 60 kg.
Operation
1. Put the slicer on the plane, adjust the four pins to make it smooth, and put the cutting adhesive.
2. Open the air source, adjust the valve switch of the oil and water separator behind, and adjust the barometer to be at least 4KG
3. Put PU adhesive on the film, put the cutting adhesive on the film, put the cutting die on the film, then press the red button switch with both hands at the same time (for safety, both hands must be pressed at the same time), press the pressure plate down to the cutting die, stay for a few seconds, let the rubber fully cut off, and then let go, take out the sample.
4. Please turn off the air source after using up.